With this setup, the TG-1 Express allows you to use a web based account to remotely control (arm/disarm) your NX-8 control panel. The TG-1 acts as a normally open relay that closes for one second and then opens. Of course, you also need a Telco connection from the RJ-45 connector on the TG-1 Express to the four Tip and Ring terminals on the GE NX-8 alarm control panel.Īfter making the proper connections, the Telguard Interactive installation guide walks you through programming the connected zone as a keyswitch zone and programming the connected auxiliary output to follow the armed state. Finally, you need to connect the 'Trp' terminal on the TG-1 to one of the 'AUXOUT' terminals on the NX-8. The zone used must be one of the eight on-board wired zones and you cannot use an expansion zone for this connection. Then, you need to wire the two 'STC' terminals on the TG-1 to an open zone on the control panel. With the NX-8, you need to connect the 'Gnd' terminal on the TG-1 to the auxiliary power 'COM' terminal on the NX-8 and the 'Pwr' terminal on the TG-1 to the 'AUX +' terminal on the NX-8. Telguard Interactive service works by wiring the TG-1 Express universal cellular alarm communicator to the alarm control panel. While Telular does a good job of providing detailed installation instructions for integrating their cellular alarm communicators with most alarm control panels, the instructions for the newer NX-6 control panel were not working for this older NX-8 and therefore, the system wasn't acting as it should. Turns light 4 ON and makes Installer Code a Master Code)ħ.Fresh off the heels of our Telular partnership, we had an interesting situation come up when trying to provide the Telguard Interactive service to one of our new customers that had an existing GE NetworX NX-8 control panel. (STAY CHIME EXIT BYPASS CANCEL, SERVICE, ARMED turns ON) (If incorrect Install code entered STAY/CHIME/EXIT/BYPASS/CANCEL will continue flashing) (STAY/CHIME/EXIT/BYPASS/CANCEL lights flash, SERVICE turns ON)
(STAY/CHIME/EXIT/BYPASS/CANCEL lights will flash)
Press # to exit or if partitioned system press * once and see below (Zone lights show Authority Level, toggle lights ON or OFF by pressing 1 to 7)ġ = Reserved, do not use 2 = Arm Only Code (Babysitter Code) 3 = Arm Only after Closing 4 = Master Arm/Disarm (Master Code) 5 = Arm/Disarm (Standard Secondary Code) 6 = Bypass Zones (Allows bypassing of zones) 7 = Open/Close Reporting (Leave OFF for Residential Accounts) 8 = If ON do not changeĤ. (If Master Code is not known see bottom of page)
0 kommentar(er)
